Alwesam Group Toshiba batteries in Syria , KSA, Lebanon

ALTANMYAH TRADING EST


Products

>>>
Primary Batteries
Battery–Powered Appliances
STANDS

Holders for Lithium Batteries

In the past, replacement of memory backup batteries was a difficult task because battery was connected directly to the circuit board through tabs spot-welded onto batteries. Now, the Toshiba Battery Holders let you change batteries quickly and easily.

Exclusively applicable for CR2025, CR2032, CR2430 and CR2450 batteries.

Equipped with a function to prevent inverted insertion of batteries.

The battery is firmly anchored in the holder.

Battery can be changed very easily and you are assured of a reliable, firm contact.

There is no battery damage from the heat when soldering to the circuit board or short circuiting in soldering tank.

Horizontal and vertical mounting types with 2 or 3 terminals are available for various usages.

Safety Precautions

If the batteries are improperly used, they may leak, heat or explode, bringing about injury or device failure, Therefore observe strictly the following matters.
Warning

  1. Do not short-circuit, disassemble, heat, recharge, deform, dispose of in fire.

  2. Do not insert batteries in reserve polarity.

  3. Keep batteries out of reach of babies and little children. If by any chance, the batteries are swallowed, consult a doctor immediately.

  4. If the alkaline solution from the battery should get in the eyes or come into contact with the skin or clothes, rinse with a large quantity of clean water and consult doctor immediately.

  5. Do not mix and use "different typos of batteries" nor "used and new "batteries" together.

  6. Do not expose batteries to strong impact by dropping or throwing the batteries.

Caution

  1. Remove promptly the used batteries from the apparatus.

  2. At the storage or disposal of the batteries, insulate the terminal parts with tape or the like. (Specially applicable to 6LR61)

Copyrights toshiba-syr.com
Development by Ebda Co.2011